13
Rebuilding/Refilling the Shocks
step 1
step 2
step 3
step 4
LOSI DSM Radio System
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
This product contains a radio transmitter with wireless technology which has been tested and found to be compliant with the
applicable regulations governing a radio transmitter in the 2.400 GHz to 2.4835 GHz frequency range.
The following countries associated regulatory agencies recognizing
the noted certifications for this product as authorized for sal
e
and use are:
USA - Belgium - Canada - Denmark - Finland - France - Germany - Italy - Netherlands - Spain - Sweden - UK
!
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Caution
Remove the lower spring cup,
spring, spring seat and any
preload shims.
Carefully remove the rubber
bladder and set it aside.
Turn the top cap counter-clockwise
until it can be removed.
Loosen the cap one turn, slowly
push the bottom of the shaft up until
it stops - allowing any extra oil to
escape.
Re-tighten the cap and check for
smooth operation.
If resistance is felt at the top
repeat bleeding steps.
1.
2.
3.
Refill or change the
fluid leaving 1/16" of
air space at the top.
Replace the bladder
and cap.
Replace the spring seat, spring
and lower spring cup. replace any
preload shims last.
Bleeding:
FINISH!
