2
1.
Your Losi Micro Rock Crawler includes 2 complete
sets of batteries. The heavy-duty non-alkaline batter-
ies are for the transmitter.
2.
Remove the battery cover by sliding it in the
direction noted on the cover. Install (8) AA alkaline
batteries into the bottom of the charger. Pay close
attention to the correct direction of the positive
(+) and negative(-) ends as marked. Reinstall the
battery cover.
3.
Plug the battery lead into the charger lead. The
RED LED on the charger will light up and stay solid
while charging. When the battery is fully charged the
light will shut off (approximately 20 minutes). If the
charger light only lights up for about a minute, the AA
batteries inside the charger are low and should be
replaced.
4.
Remove the transmitter battery cover by sliding it
in the direction noted on the cover. Install four (4) AA
batteries into the battery holder. Pay close attention to
the correct direction of the positive (+) and negative
(-) ends as marked. Once all 4 batteries have been
installed, reinstall the battery cover.
5.
Plug in the battery lead into the speed controller
lead and replace the body. Secure the body with the
included body clips.
6. ALWAYS turn on the transmitter first by sliding the
switch “ON”. The small red and green lights above the
switch should both light up. If not, please check for
low or incorrectly installed batteries.
7.
Once the transmitter has been turned on, turn on the Losi Micro Rock Crawler by sliding the switch to the
“On” position (located at the rear of the chassis). If the wheels spin, adjust the “TH. Trim” knob located to
the lower right of the steering wheel until they stop. To go forward pull the trigger back. If you should need to
reverse, wait for the model to stop then push the trigger forward. When going forward the model should move
in a straight line. If not, adjust the “ST.Trim” so that it tracks in a straight line without having to turn the steer-
ing wheel. After you are finished running, turn the Losi Micro Rock Crawler off FIRST by sliding the switch to
the “Off” position. After the model has been turned off, turn off the transmitter.
RTR Getting Started
Charger
