EN
12
DBXL-E 2.0 RTR, AVC: 1:5 4WD DESERT BUGGY • INSTRUCTION MANUAL
VEHICLE MAINTENANCE
The following items require semi-frequent maintenance. Always clean screw threads and apply
removeable thread locking compound when threading machine screws into metal parts.
Remove the shocks and service as needed. Replace worn parts.
1.
Pull the spring up and away from the lower cup. Slide the lower spring cup up and off
of the shaft. Clean with a soft brush. Remove the shock boot.
2.
Use the wheel wrench to hold the shock body and remove the top cap.
Empty the fl uid from out of the shock.
3.
Hold the shaft with a multi-wrench and remove the shock end. Push the shaft into the
shock body and remove through the top. Remove the lower shock cap, dust cover, O-
rings and spacer. Clean the shock body. Install new O-rings, re-install the spacer, replace
the O-ring and install the lower shock cap. DO NOT TIGHTEN. Install the shock shaft
through the shock bottom and tighten the bottom cap. Re-install the boot and shock
end on the shaft.
SHOCK DISASSEMBLY/CLEANING
FRONT
REAR
Tip: Clean the screw and internal threads in the shaft with a spray cleaner. Use
Medium Strength Threadlock. (Refer to fi gure 3.)
1.
2.
3.
