Setting up the TEAM UHF-DualTalk
1) Inserting the batteries
Turn the unit in that way that the rear panel lies in front of you. Rotate the belt clip a
quarter turn counter-clockwise, so that the battery compartment lid is accessible now.
The locking of the battery compartment lid is located at the bottom side of the unit.
Push the locking aside and turn it down. Then you can take the lid off.
Now insert 4 alkaline or rechargeable AAA ( = Micro ) cells into the battery compart-
ment according to the polarity signs inside. If you use rechargeable cells we recom-
mend the NiMH type.
To close the battery compartment put the lid onto the compartment in that way that the
two guide bolts at the top of the lid grip into the two corresponding guide holes at the
top of the battery compartment. Then secure the lid by pushing the locking on it until
it snaps in. Finally rotate the belt clip back into its original position
2) Switching On/Off
Depress the confirmation CONFIRM and On/Off key ( 5 ) for about 1 or 2 seconds
to switch the transceiver on. A short receipt tone sounds from the loudspeaker ( 6 )
and the display illumination lights up in green. For a short period the graphic display
( 3 ) shows all points. Now the unit is either in PMR reception mode or in LPD recep-
tion mode. The display will show the main screen which indicates also the actual
band. To switch the unit off depress the confirmation and On/Off key ( 5 ) again
for about 1 or 2 seconds. The loudspeaker gives a short tone and all symbols disap-
pear from the display. The last settings remain memorised, even if the batteries are
removed.
English
6
