18
19
English
BASIC FUNCTIONS
Antenna
In the PMR version, due to governmental regulations, the
antenna is fixed, i.e. non-detachable.
Battery Pack
To attach the battery pack (11), place the battery pack onto the radio and press the
bottom part close to the radio case and close the lock.
Charging
Prior to first use, the battery pack has to be charged completely. A completely
empty battery pack needs to be charged for approximately three hours. During the
charging process, the LED lights red. Once charging is completed, the LED lights
green.
Remove the battery pack out of the charger. Overcharging reduces the battery
packs longevity.
On / Off
To turn the radio on, turn the On / Off switch (2) clockwise beyond the barrier. A
beep tone is emitted if the beep tone function is activated.
To turn off the radio, please turn the On / Off switch (2) counterclockwise beyond
the barrier.
Volume Control
To set a comfortable volume level after turning the radio on, activate the monitor
function by pressing the according multi-functional key PF1/2 (9) (which has to be
programmed via software) while adjusting the volume level with the combined
On/Off-Volume key (2).
Channel Selection
For channel selection, use the rotary channel selector (3) switch.
The channels are selected in the programmed order.
English
Transmit
For transmission hold the PTT key (8) until the end of the message.
For best sound quality, talk into the microphone (4) with normal voice at a distance
of approximatly 10 cm.
During transmission the control LED (6) lights red.
Upon release of the PTT key (8) the radio returns automatically into reception mode.
Reception
Upon reception of a signal, the LED (6) lights green.
If the selected frequency is decoded with a CTCSS- / DCS-code, all signals that
are encoded with a different code will be muted. The green LED will light but no
signal will be audible.
KEY FUNCTIONS
PTT Key
The PTT key (8) is located at the left side of the radio. Pressing the PTT key will
switch the radio into transmission mode. The LED (6) will light red.
Multi-Function Keys
The multi function keys PF1 and PF2 (9) are located below the PTT key (8). Each of
them are programmable via the software T-UP31 with two of the following functions
that are activated by pressing short or long:
Monitor
Scan VOX
Priority Scan
Revert Frequency
Offline
Power (Low/High)
monitor
The monitor functions remains active until the key is pressed again.
scan
Start / stop the channel scan function by pressing the key. Each channel can be
added to or deleted from the scan list by software programming.
This function is only available if at least two channels are added to the scan list.
tecom-ip3_manual_3:Layout 1 7/24/2015 12:37 PM Page 18
