16
:: Bag 9 - Step 5
:: Bag 9 - Step 4
:: Bag 9 - Step 3
Front Shock: 30 wt
#5422
Rear Shock: 30 wt
#5422
Shock fluid
Steps 9-10
Step 8
Steps 6-7
Steps 4-5
Steps 2-3
Shock Bleeding Steps:
1.
Before assembly, get each bleed
screw and thread it 1-2 turns into
the shock cap, then remove the
screw. This will make it easier when
you are bleeding your shocks.
2.
Pull shock shaft down.
3.
Fill shock body 3/4 full with silicone
shock fluid.
4.
Slowly move the shock shaft up and
down to remove air from under the
piston.
5.
Wait for bubbles to come to surface.
6.
Fill shock body to top with silicone
shock fluid.
7.
Place a drop of oil in the cap and on
cap threads.
8.
Install cap (without bleed screw) and
tighten completely.
9.
Slowly compress shaft all the way to
bleed excess silicone shock fluid out
the hole in the cap (use rag around
shock to catch excess fluid).
10. Install M2x4mm button head
screw until snug while shaft is fully
compressed.
91492
M2 x 4mm
BHCS
91814
12mm
Shock Cap
Stroke
Front: 20.5mm
Rear: 28mm
Stroke
Shock fluid
91304
12mm
Threaded
Collar
91304
12mm
Threaded
Collar
O-ring
x4
x4
91814
12mm shock
spring cup
(Front - 5mm
Rear - 5mm)
91831
12mm Front
Spring, White
(3.40lb)
91838
12mm Rear
Spring, White
(1.91lb)
Front:
3.00mm
Rear:
9.00mm
Build x2 front and x2 rear shocks
Racers Tip:
Use your finger to rub
shock oil on the o-ring for
smoother adjustment!
#91310 12mm Shock Spring Cups
0mm
5mm
9mm
Use outside
hole in
front arm!
!
25612
M3 Locknut
w/Flange
25612
M3 Locknut
w/Flange
25187
M3 x 14mm
BHCS
25188
M3 x 20mm
BHCS
Build x2 (right and left side)
Build x2 (right and left side)
Make sure the
flange on the
shock pivot ball is
towards the rear
arm.
!
