Free Standing
This unit has been designed to be used only in an upright position on a firm, flat
level surface.
The unit can safely be used both indoors and outdoors.
Failure to follow these instructions may result in personal injury, damage to the
product or damage to property.
Ensure that the position of the unit allows sufficient space for the lifting on and
off of the clean water tank (top) and the removal of the waste water container
(right hand side).
Remove the red filler cap to add clean, fresh water. Replace the cap when the unit
has been filled to the correct level.
Do not over-tighten fixings as this may damage the unit.
Check that the unit is upright and level before filling.
Waste Water
All KiddiSynk models come complete with a removable waste water container
that retains all the dirty water.
There is no need for a separate waste pipe or waste water storage container.
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY INVALIDATE YOUR WARRANTY.
Installation
The unit can be filled with the clean water tank in place on top of the unit if
required.
The clean water tank can also be lifted from the unit to be carried to a water
source such as an outside tap. Hold the handles of the clean water tank firmly in
order to lift it away from the unit.
Ensure that the location pegs on the base unit are slotted accurately into place in
the water tank location holes when repositioning the clean water tank. S
ee the
relevant
parts identification
photograph on page 7.
Remove the filler cap at the top of the unit and add clean, fresh water.
Unit must only be filled with clean water of the required temperature, which
should not exceed 40˚C.
Do not overfill - only fill to the water fill line indicated on the relevant
parts
identification
photograph on page 7.
Replace the filler cap.
Ensure that the white waste water container inlet has been pushed into place
beneath the waste water pipe - see the relevant
parts identification
photograph
on page 7.
Use the tap to discharge water to wash hands.
If a continuous flow of water is required, fully depress the tap lever.
Waste water will drain into the waste water container.
To remove waste water, remove the water container and lift it out.
Tip the water from the water container into a foul water drain.
Rinse with clean water.
Refill the unit and with clean water of the required temperature, which should not
exceed 40˚C.
Operating instructions
Page 8
Page 9
