2
1
3
4
5
6
✓
✓
✓
7
8
9
Step 5
Step 7
Step 9
PAYLOAD MOUNTING BRACKET REPLACEMENT
The gimbal brackets can be easily replaced in the field; however, the black silicone gimbal dampers
cannot. If the dampers need to be replaced or serviced, please contact Teal Drone Customer Support or
an authorized service center.
REPLACEMENT
INSTRUCTIONS
Place the drone on its back on a table or workspace where the antenna can
hang off the edge to prevent being damaged.
Make sure that the camera data cable and gimbal motor cable are not
strained in any way.
Remove the two (2) M3 x 8mm screws on the gimbal brackets using a T8
Torx screwdriver.
Tools Needed:
One (1) T8 Torx Screwdriver
Removal:
Two (2) M3 x 8mm Screws
Set the screws aside for re-use.
Use your fingers or plastic pliers that will not
damage the silicone damper to hold the body of
one of the front dampers in place (as shown in
the image to the right).
Firmly, but slowly, pull the bracket away from the
damper body until the end of the damper pulls
through the hole.
Follow the same directions to remove the rear
damper (as shown in the image to the right).
Remove the remaining dampers.
Set the new bracket so that the recesses for the
screw head and dampers are visible and away
from the body of the drone (as shown in the
image to the right).
Manually move the gimbal pitch and roll axis and check for binding or obstructions.
Ensure that no wires are pinched.
Power on the system and confirm the gimbal properly functions and is properly oriented.
SYSTEM
CHECKOUT
04
© 2022 Teal Drones, Inc.
SUP-00005, REV A
