32
Titan Neo
product description
TROUBLESHOOTING
Sorting out LCD ERR message
The ERR message may show up on the units UT-96HH, UT-96BP, DR-800 and TX-
800. In brief, any wireless based devices that carry a LCD panel might have this
potential problem. The feasibility of such kind of rick shall be quite few, but it might
occur. Following I will give you a instructions to kill this problem. LCD panel works
“normally” when shown as below…
Generally, there are two possibilities that bring “Error” message to the devices,
software or hardware problem. Following instructions will lead you to sort out
problems caused by software.
1. RESET built in software by pressing and holding “SET” + “UP” + “DOWN” then
Switch unit on.
2. How to know if the RESET is done successfully? “On” message will be shown on
the LCD panel and it will stay on “On” message—it won’t display the channel
last used.
3. When you've successfully cleared the “ERR” message, switch the unit off, then
on. Now use the transmitter normally.
“On” shown on the LCD panel when unit was switched on.
In 1–2 seconds, the LCD panel will show channel number that was used last time
on the LCD panel.
SET
UP
DOWN
SET
UP
DOWN
SET
UP
DOWN
