Teac W-890RMKII, Owner'S Manual

Page: 18 / 72

18
Recording (continued)
Continuous recording
This function allows you to make uninterrupted recordings on both
sides of two tapes.
1
Load cassette tapes for recording into the TAPE
I
and
TAPE
II
compartments.
Side “A” facing you
2
Set the REV MODE switch to the
p
(CONT REC/PLAY)
position.
3
Press the TAPE
I
deck’s RECORD (
K
) key.
The deck enters the record-pause mode.
J
and will light
on the display. Now adjust the recording level and any other
settings, as required.
4
Check the recording direction.
If an indicator is lit which points in the direction opposite to
the one desired, change the direction by pressing the opposite
direction
PLAY (
h
or
y
) key.
NOTE
Be careful not to press the
PLAY
(
h
or
y
) key whose arrow
points in the same direction as the indicator. Doing so will start
recording.
Recording is done in this order:
TAPE
I
Side “A”
x
Side “B”
x
TAPE
II
Side “A”
x
Side “B”
You can start recording from side “B” of TAPE
I
. But if you do so,
side “A” of this tape is not recorded: when recording reaches the
end of side “B”, the TAPE
II
deck starts recording.
NOTE
The TAPE
II
deck always starts recording from side “A”.
5
Start recording.
Recording starts when you press the PAUSE key or the PLAY
(
h
or
y
) key whose arrow points in the same direction as the
indicator on the TAPE
I
deck.
When recording is finished on the TAPE
I
deck, the TAPE
II
deck
automatically starts recording.
NOTE
The transition from TAPE
I
to TAPE
II
takes several seconds.
A
To stop recording
Press the STOP (
H
) key of the deck which is currently recording.