EN
7
Check to be sure the box includes all the supplied accessories
shown below. Please contact the store where you purchased this
unit if any of these accessories are missing or have been damaged
during transportation.
Power cord × 1
Remote control (RC-1338) × 1
Batteries for remote control (AAA) × 2
Foot pads × 3
Owner’s manual (this document, including warranty) × 1
o
For information about the warranty, users living in the USA and
Canada should see pages 104–105 and the back cover (war-
ranty document). Users living in Europe and other regions should
see page 105.
Using the TEAC International Site
You can download updates for this unit from the TEAC International
Site:
https://teac.jp/int/
Click Language at the top right of the page and select the desired
country or region to access a page in the corresponding language.
Included accessories
Before use
o
This equipment is very heavy, so take care to avoid injury when
opening the packaging and when moving it.
o
The handle-like parts on the left and right sides of the front panel
are decorative. Do not put your fingers through them or use
them to carry the unit.
o
Do not install this unit in a location that could become hot.
This includes places that are exposed to direct sunlight or near
a radiator, heater, stove or other heating equipment. Moreover,
do not place it on top of an amplifier or other equipment that
generates heat. Doing so could cause discoloration, deformation
or malfunction.
o
Avoid locations that are subject to vibrations or exposed to
excessive dust, cold or moisture.
o
When installing this unit, leave a little space (at least 3 cm or 1
"
)
between it and walls and other devices in order to allow good
heat dissipation.
If you put it in a rack, for example, leave at least 5 cm (2
"
) open
above and 10 cm (4
"
) open behind it. Failure to provide these
gaps could cause heat to build up inside and result in fire.
o
Place the unit in a stable location.
o
Do not place anything on top of the unit.
o
Do not lift or move the unit during playback because the disc
rotates at high speed. Doing so could damage the disc.
o
Always remove any loaded disc before moving this unit or pack-
ing it for installation in a different location, for example. Moving
the unit with a disc inside could cause damage.
o
The voltage supplied to the unit should match the voltage
printed on the back of the unit. If you are in any doubt regarding
this matter, consult an electrician.
o
Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock. If a foreign object should
get into the unit, contact your dealer.
o
When removing the power plug from the wall outlet, always pull
directly on the plug; never yank on the cord.
Note about pinpoint feet
High-precision metal pinpoint feet are attached to the bottom plate
of this unit.
The pinpoint feet and their stands are loose, but when the unit is
placed in position, it is supported by these pinpoint feet, which
effectively disperse vibrations.
Chassis
Pinpoint foot (metal)
Foot-stand (metal)
Screws that
attach foot-stand
o
The included foot pads are intended to protect the surface
where the unit is placed. Apply them to the bottoms of the foot-
stands to avoid scratching the surface where the unit is placed.
