Teac CS-Single-12, User Manual

Page: 20 / 34

48
ENGLISH
The display shows the same messages, under the same circum-
stances, except that the word
Copy Copy
Copy Copy Copy
is replaced by the word
Test Test
Test Test Test
in all these messages.
At the end of the test procedure, the CS-Single-12 does not simu-
late the writing of the TOC (the finalization process), and displays:
NOTE
There is one other important difference between test write
mode and copy mode. You can interrupt the test write mode
part of the way through the operation without affecting the
slave CD-R media. If you interrupt a copy procedure part of
the way through the operation, the CD-R becomes unusable.
To interrupt the test write operation, press and hold down the
MODE key. The display will show
Exit Exit
Exit Exit Exit
. When this is displayed,
press the ENTER key. This cancels the test write process,
and the display returns to the initial status screen. If you press
the MODE key while
Exit Exit Exit Exit Exit
is shown on the display, the dis-
play returns to the test write display screen.
3.3 Possible Problems When Copying or in Test Write
Mode
If the MASTER or SLAVE drive does not contain a disc, or if the disc
cannot be read by the drive (it is upside-down or badly positioned in
the tray), the display will show
No disc No disc
No disc No disc
No disc
.
If the SLAVE drive does not contain a recordable CD-R disc, or a CD-
R disc which has been previously partly recorded, the display will show
Bad disc Bad disc Bad disc Bad disc Bad disc
.
The standard maximum length of an audio CD is set at 74 minutes.
However, some commercial CDs are recorded with a running time a
little longer than this. If the master audio CD exceeds 74 minutes in
length (or the standard maximum amount of data (650 MB) for a CD-
Test write Test write Test write Test write Test write
Finished Finished
Finished Finished
Finished
3. Modes