TECP-90-703 • Issue 1 • 8/2012
Page 4
© 2012 Tyco Electronics Corportation. All Rights Reserved.
•
Guide Strip
—provides cable management for fibers routed into the chassis on the front or
rear of the frame.
3
GROUNDING AND BONDING THE CHASSIS
The standard chassis uses thread-forming mounting screws to provide an electrical path
between the chassis and the metalwork in which it is mounted. It is required that nonconductive
coatings must be removed on the mating metal surfaces. Before installation the mating surfaces
must be cleaned and coated with an antioxidant.
4
CHASSIS INSTALLATION PROCEDURE
1. Identify the frame location where chassis will be installed. Prepare area around mounting
holes to provide a good ground (remove paint, clean, and coat with rust preventative).
2. Install screws and star washers into the two left side holes on the rack to hang the chassis
on the rack, then install screws and washers in the right two holes. See
Figure 2
.
Figure 2. Installing Chassis in Frame
Note:
The frame has six locations for mounting of the chassis.
24940-A
