TECP-90-703 • Issue 1 • 8/2012
Page 3
© 2012 Tyco Electronics Corporation. All Rights Reserved.
• Access trays can also be loaded with cabled modules that snap into position. Each cabled
module is pre-terminated with 24 LC or 12 SC adapter/connectors and fibers. Snap-in
MPO and VAM modules are also available.
• Routing guides manage the fibers within the chassis, allowing an access tray to be opened
or closed with no pulling or pinching of fibers.
2
MAIN COMPONENTS
Figure 1
shows the main components of the standard chassis. They are as follows:
Figure 1. Main Components of NG4access Standard Chassis
•
Access Tray
—can be moved toward front or rear to provide front or rear access to adapter
packs with the associated fibers and connectors. In place of adapter packs, each access tray
may hold a snap-in cabled module, MPO module, or VAM module.
•
Tray doors
—swing out when an access tray is opened. Tray doors protect the individual
access trays and provide laser eye protection.
•
Universal Adapter Pack (LC or SC)
—
can be used with singlemode or multi-mode, APC
or UPC connectors. LC packs have 24 adapters. SC packs have 12 adapters,
•
Routing Guide
—holds fibers in an optimal route when access trays are moved toward the
front or rear of the chassis.
•
Mounting Tab
—provides a physical interface for mounting the chassis on a frame. The
tabs hold four mounting screws, two on each side.
24948-A
TRAY
DOORS
ACCESS
TRAY
NOTE:
CHASSIS DOORS
NOT SHOWN
ROUTING
GUIDES
MOUNTING
TAB
GUIDE
STRIP
GUIDE
STRIP
UNIVERSAL
ADAPTER PACK
(WITH LC
CONNECTORS)