408-2823
Rev
AB
5
of 13
6. While holding the tool so that the back side is facing you, insert the stripped wire into the wire barrel
until the wire bottoms (Figure 4).
Figure 4: Inserting the wire
1
Stripped wire
2
Back side of tool
3
Upper die
4
Locator assembly
5
Wire barrel
7. While holding the wire in place, squeeze the tool handles together until the ratchet releases. Allow the
tool handles to open
fully
.
8. Remove crimped terminal or splice from the tool.
9. If crimping a splice, position the uncrimped wire barrel in the crimping chamber. Make sure to seat the
splice window indent on the locator assembly. Repeat steps 5 through 7.
CAUTION
Do not use damaged or worn terminals. Terminals can be removed from the wire, discarded, and replaced with new ones.
