408-32166
Rev A
3
of 3
3. Close handles on crimping tool until ratchet releases allowing handles to open.
4. Remove crimped contact.
Ferrule
(Figure 4)
Refer to the table in Figure 1 and select the appropriate hand crimping tool for crimping the ferrule. The
instruction sheet numbers are listed with the tools.
1. Insert the crimped center contact and cable into the appropriate pin or socket body.
NOTE
The cable dielectric should bottom against contact body dielectric, and braid on cable should fit over braid support section of
contact body.
2. Position ferrule over braid and against shoulder on contact body.
3. Place the cable assembly into the crimp section indicated on the table. Shoulder of contact body
should be against tool jaw.
4. Crimp the ferrule until the ratchet releases, allowing handles to open.
Figure 4
5.
REVISION SUMMARY
Initial release of document
Ferrule
Braid Over Braid
Support Section
Place Ferrule on
Crimping Die
Shoulder on Pin
or Socket Body
Butts Against Die
