409-32023
Rev
B
34 of 41
About Page
The
“About Page” displays the version of the various software and firmware programs in the unit. This can
useful to identify the current versions of software and determine if an upgrade is needed. See Figure 53.
Figure 53
4.
SYSTEM III TERMINAL SERVO FEEDER OPERATION AND CALIBRATION
4.1.
Feeder Operation
1. Attach the appropriate feed finger to the terminal feeder using the quick-release pin.
NOTE
The required feed finger is identified on the applicator identification tag and in the data storage device on the applicator (the
data can be displayed though the software in the system III precision controller).
Figure 54 shows the side feed finger assembly and the end feed finger assembly. The side feed finger
features a replaceable tip that can be flipped over to provide an additional feed tip. Note the
orientation of the quick-release pin (shown in Figure 54).
Figure 54
2. Flip the side feed finger into the up position. A spring-loaded detent will hold it in place.
3. Install the feeder into the applicator as shown in Figure 55. Flip the feed finger down. For a side-feed
applicator, make sure that the feed finger is positioned in the feed track groove. See Figure 55.
Side Feed Finger Assembly
End Feed Finger Assembly
Quick-Release Pin
Quick-Release Pin
Downloaded From
