409-32023
Rev
B
32 of 41
The Up and Down navigation keys can be used to navigate down the right side of the screen to any of the
outputs. Pressing the Enter key on any of the outputs will cause the output to toggle to the opposite state
as depicted by the light next to the output. All outputs should be
displayed as off and only the “Servo
Safety Status” input should be displayed as on. Refer to Figure 49.
Analog I/O Page
This page displays the serial numbers of the one-wire devices for the feeder and applicator.
The “Elmo drive temperature” is displayed in degrees Celsius. See Figure 49.
Figure 49
Settings Page
On this page, the language can be changed by moving to the Language Edit field using the Up and Down
arrow keys and then pressing the Enter key. A pop-up selection box will appear, the user can scroll to the
appropriate language and press the Enter key to select it. Ethernet settings are used for TE internal use
and typically should be left alone. See Figure 50.
LCD calibration is typically only done at manufacturing time and should not be changed. If a user
inadvertently enters the calibration routine, the Cancel key can be pressed several times, and it will exit
out of the Calibration mode.
Figure 50
I/O Interface Icon (Ref)
Digital I/O Page
Analog I/O Page
Serials Numbers of One-Wire Devices
Settings Page
Diagnostics Page
Downloaded From
