TDR VMI QUICKSAND, User Manual

Page: 10 / 14

Replacing Jet Nozzle Extenders
1. Pull off the existing Jet Nozzle Extenders
and discard.
2. Push on the new ones found in your
consumables pack.
Replacing the Credit Chip
The machine will notify the Operator to replace
the Credit Chip by displaying the “RC” message
(replace consumables). All consumables must
be replaced at this time!
1. Turn OFF power to the unit.
2. Remove and discard the depleted Credit
Chip then install the new one.
3. Once the new Credit Chip has been
installed and the machine is powered back
on, the “RC” message on the Main Screen
will disappear, and the “Supplies – Fuel
Gauge” will display the new credit.
Note: The Fuel Gauge will display 100% with a
100 minute Credit Chip.
If a 50 minute starter Credit Chip is installed,
the Supplies Gauge will only display 50%.
Care and Maintenance
Cleaning the Catch Tray
Over time your Catch Tray may build up with
plastic residue from the Sanding Process. There
is no set time for when this item needs to be
cleaned. However, we strongly recommend at least
cleaning the Catch Tray every time a new set of
consumables is installed.
1. Make sure the Lid is in the “Open” position.
2. Remove the Lid Stopper from the back of the
Lid.
3. Let the Lid gently open to its farthest position.
4.
Pull off the Turntable from the Main Motor
shaft.
5. Locate the removable Catch Tray. Pull up on
the outer edges of the tray and remove from
the machine.
6. Rinse the Catch Tray under warm water until
all of the plastic remnants are washed away.
7. Make sure that the Catch Tray is dry before Re-
installing into the machine.
8. Re-install the Catch Tray.
9. Re-install the Turntable onto the shaft of the
Main Motor.
10. Re-install the Lid Stopper.
Putting the Machine into storage
Make sure to keep the Lid in the “Open” position.
This will ensure that the Foam Pads will not
become flat.
Caution: Flat pads may produce inferior results.
Note: If you desire to keep the Lid in the “Closed”
position while not in use, remove the Turntable
from the machine.
Page 8