AN-000227
Document Number: AN-000227
Page 9 of 15
Revision: 1.0
•
From the Device Programming screen scroll to the project’s Debug directory and select the s
martsonic-
presence-example.hex
file.
o
Note
: Alternately, you may use the
smartsonic-presence-example.elf
file, which contains
symbolic debug information. (Both files are generated when you build the application. If you are
simply running the Presence Detection application, and do not need to use the Atmel Studio 7
debugging features, it does not matter which file you use.)
•
Select
Program
. Your SmartSonic board is successfully programmed when the Device Programming screen
displays the “OK” messages shown below on the bottom left:
Figure 5. Successful Programming
RUNNING THE PRESENCE DETECTION APPLICATION
•
Start the terminal emulator program and open/configure the COM port assigned to the SmartSonic board
“EDBG”:
o
1000000 baud
o
8 bits data, no parity, 1 stop bit
o
New-line sequence = Line Feed only (no carriage return)
PuTTY: Open
Terminal
configuration. Select
“Implicit CR in every LF”
.
TeraTerm: Open
Setup > Terminal
.
Under
“New-line”
set
“Receive”
to
“LF”
.
