AN-000350
Document Number: AN-000350
Page 4 of 13
Revision: 1.0
CONNECTIONS
As shown in Figure 3, USB1 is used for power supply and for serial interface with the board. USB2 is used as port
for debug messages, and USB 3 is used to load the firmware image.
INSTRUCTIONS TO LOAD THE ROBOKIT FIRMWARE IMAGE
Connect a micro-USB cable to USB1 for power supply (note that when USB is connected to the USB1 Power port,
the LEDs D1 and D2 at the top right corner should be turned on), and connect a micro-USB cable to USB 3 EDBG
port for loading the image, turn ON the four switches “SW5” (move them towards the blue push button) and run
following command.
edbg-b61-WINDOWS-175e58c.exe -b -t same70 -pv -f rkbin-1.0.20211025.088a.bin
Where
rkbin-1.0.20211025.088a.bin
is RoboKit firmware
