TCSM CE Series, Installation, Operation And Maintenance Manual

Page: 14 / 23

Electrostatic Oil Mist Collector CE Series
13
5.Installation and operation instructions
1
5.1
Installation instructions
2
3
5.1.1.
4
Check the main voltage and frequency by comparing the
5
specification on the utility meter with the specification on the
6
machine rating plate. The power supply needs to be grounded. Be sure to
7
turn off the primary power side before installing the machine. Primary
8
side 3 phase circuit breaker rated current should be 15A large then
9
the collector rated current.
10
11
The voltage fluctuations must be in the range of -5 % to 10 %. In
12
case of major fluctuations, faults and premature wear can be expected.
13
In this case, the warranty will no longer be valid.
14
15
5.1.2. Depending on customer field application, CE series of
16
collectors have three installation ways:
17
(1) Install on the machine directly.
18
(2) Install on support column (Support column height customizable).
19
(3) Whole factory machine tools oil mist solution. Solution is
20
proceeded with CE series collectors and air duct.
21
22
5.1.3. Oil mist intake place suggestions:
23
5.1.3.1 Usually set oil mist intake place on machine tool top cover
24
or side cover.
25
5.1.3.2 Oil mist intake place should prevent nearby or opposite
26
machine tool coolant nozzle. If this situation could not be prevented,
27
user should install oil mist intake cover (plastic/steel) to reduce
28
oil drop intake volume.
29
5.1.4. Connection between air duct and CE series collectors should not
30
leak, and air duct layout should prevent oil accumulation inside air
31
duct. Also, could install “Front oil blocker” or PVC pipe to
32
prevent above problem.
33
34