Locate the two tank support legs
and set them on the floor of the
van near the fresh water tank.
Slip strapping clamps around
the top portion of the fresh water
tank. Leave them loose.
Stand tank support legs into the
approximate position against
fresh water tank.
Slide straps down over the
support legs.
Strap support legs to tank using
two strap clamps. Tighten
securely
Drill 3/8” holes in floor of van
to bolt tank support legs down.
Check below van before drilling.
Drop a 5/16”x2” bolt with a flat
washer through each hole. From
below, install a fender washer and
a locknut on each bolt.
Determine which side the reels
will go on, and set into place.
Generally, it is best to set the
reels as close as possible to the
wheel well, and as close to the
doors as possible. Check to make
sure the doors will close before
drilling mounting holes.
WARNING: Check below van to
make sure that you will not do
any damage when drilling the
holes for mounting the reels.
It is recommended that you take
down the spare tire to prevent
damage and make this
procedure easier.
Drill four 3/8” holes through base
of reels and floor of van.
8
