Jumper Position Description
(1) TERM
Insert this jumper to add termination to the LCC-CAN bus.
An LCC-CAN bus should have
exactly two
terminators,
with one at each end of the bus. This jumper can (optional
-
ly) provide for one of the required terminators. In practical
-
ity, a very short (less than 10ft or 3m) LCC-CAN bus can
still work reliably with one terminator.
(2) N/A
Not used.
(3 & 4) DCC/F
Insert these two jumpers to pass the low power DCC
signals through the LCC panel (pins 4 & 5 of the LCC-CAN
standard).
Remove these jumpers to disconnect the low power DCC
signals from passing through the panel.
The LT Panel uses the NMRA S-9.1.2 Full Scale Interface
Configuration Jumpers
DCC/F Simplified Diagram
5
Summary of Contents for LT-50
Page 1: ......