Tcrea Cirmy FREEDOM, User Manual

Page: 19 / 24

19
Tcrea srl - Freedom User Manual- V.1-2020
USE OF THE DEVICE
FREEDOM’s MAINTENANCE
REPLACEABLE PARTS: THE DUST PRE-FILTER
- Follow the instructions in this manual to replace the dust pre-filter.
- The dust pre-filter in use is not washable.
- Failure to replace the dust filter when overloaded may cause the product to
function incorrectly.
- To order the new dust pre-filters visit www.cirmy.it/
WASHABLE PARTS: THE FILTER BLOCK
- WARNING: The filter block, unlike the dust filter, is washable.
- To clean the filter block, just wash it under warm water and let it air-dry .
- Follow the instructions in this manual to clean the filter block.
- To maintain maximum efficiency, Tcrea srl recommends to wash the filter
block regularly (at least every 90 days), and possibly replace it after 48 months.
To turn on Freedom, select one of the two operating speeds I (minimum speed)
or II (maximum speed) trhough the power switch.
To turn off Freedom, set the middle position or the 0 position on the switch.
In order to always obtain the best performance from Freedom, it is important to
clean it following the indications in this manual and verify the possible presence
of blockages on the dust filter, with regularity.
CLEANING
- If dust accumulates on the surface of the device, remove it using a soft, dry or
slightly water damped cloth.
- Periodically check the presence of excessive amounts of dust in the dust pre-
filter located at the bottom of the device and replace it as shown on page 8.
-For external cleaning of the device use only a soft cloth.
- WARNING : Do not use detergents or polishes.
- WARNING: Do not use alcohol, soaps or solvents.
- WARNING : Do not spray or apply in any way perfumes, environmental
deodorants or essences to perfume the environment, unless approved by Tcrea
srl.