1
Connections and setup
Before initial setup
Protect against power surges
Connect all components before you plug any power cords into the wall outlet or power strip.
NEVER plug your TCL • Roku TV into an outlet that is controlled by a wall switch.
Turn off the TV before you connect or disconnect any cables.
Make sure all antennas and cables are properly grounded. Refer to the Important Safety
Instructions.
Safety information
Prevent TV from overheating by placing in an area with good ventilation.
Do not block ventilation holes on the TV. Position the TV so air can circulate freely on all sides.
Do not stack objects on the TV.
If you place the TV on a stand, make sure you allow adequate ventilation.
If you connect an audio receiver or amplifier to the TV, place it on the top shelf so the heated air
will not overheat the TV.
Avoid audio interference
Position cables properly; insert each cable firmly into the designated jack.
Route all cables down one side of the back of the TV instead of straight down the middle.
If your antenna uses 300-ohm twin lead cables, do not coil the cables.
Keep twin lead cables away from audio/video cables.
Avoid direct light
Do not place the TV where sunlight or room lighting is directed toward the screen. Use soft or indirect
lighting.
