8
Wall Mount
Follow the steps below:
Figure for Hole Spacings
1. Drill the 5 holes with 7MM in diameter on the wall. The hole spacings are as shown
below;
2. Make the 5 expanding stopples into those holes and level them with the wall surface;
3. Tighten the wall bracket with the self tapping screws, levelled with the wall surface;
4. Tighten the support and the monitor with the machine screws;
5. Then put the device installed on Step 4 on the trapeziform glide slot of the wall
bracket.
Summary of Contents for ML20
Page 10: ... ...