6
Remote Control
Transmitter
MENU
· Pop up and exit the main menu;
· Return to the previous menu.
UP button
·
Act as the SOURCE button and
OK button.
DOWN button
·
Select the downwards options;
·
Under the Source menu, select
the signal input.
RIGHT button
· Select the main menu options;
Make the adjustments of submenu
options(Change/Increase the values)
LEFT button
· Select the main menu options;
Make the adjustments of submenu
options(Change/Decrease the values)
NOTE:
UP/DOWN buttons and LEFT/RIGHT buttons take effect only in the MENU mode.
Battery Installation
Remove the battery compartment lid from the back of the remote, insert the 2 x 1.5V
AAA batteries, paying attention to the polarity, and then replace the cover.
Using the Remote Control
Wireless Remote: No need to connect it with the remote jacks. Point this wireless remote
directly toward the infra-red sensor on the unit. If there is an obstacle between the unit
and the remote,the remote signal may not be received.
NOTES:
1. For better performance, once you find the operation is abnormal, please replace the
batteries and have a try again.
2. Do not mix old and new batteries or different types.
3. When the batteries are to be exhausted, battery leakage may occur and cause the
damage to the remote. When the operation is not sensitive enough, the battery may be
low, so please change batteries immediately.
4. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible leakage.
Summary of Contents for ML20
Page 10: ... ...