6)
After update finished, power off the TV, then power on, at the first time that you power
on the TV set, the display will be later than normal.
II
Update through the VGA port.
1)
Connect by the cable (the tool and the cable) between the PC and the VGA port.
2)
Power on the set, press the key of the factory remote control. After repeat that process
3,4,5,6 above, please note when doing the process 6, must erase flash first: press
“ERASE FLASH”.
3.5 The DDC data should be programmed before SMT, and it also can be updated through
P2 (VGA) when finished SMT.
3.6 After download the software, it need about 30 second to initialize the EEprom, so must
write the data to U2 before SMT.
3.7 IC need to be update
Location
Materiel NO.
Virtual coding
U2
13-M24C32-MNB
E2PROM
15
