第
8
页共
11
页
4、Service Menu
1、Methods of Entering
Using the remote, enter the “Picture” submenu in the OSD; choosing the
“contrast” item and press the 9,7,0 and 5 in series, Service Menu will appear in
the left top of screen
SERVICE MENU：
ITEM
Defau
lt
Setti
ng
Description
Status
1-Factory hotkey Off
Factory hotkey Switch (OFF/ON).Should be OFF
after factory alignment
OK
2-WARM-UP
Off
OFF：The set would enter standby mode after 15
minutes without input signal；
ON：Aging mode. Aging time will display on the
left bottom of screen.
NOTE: Enter and exit the aging mode method: 1, press
on the remote control Left and right the cursor keys will
Factory hotkey set to ON; 2, WARM UP is set to ON;
according to the panel on the "menu" button to exit the
aging mode
OK
3-ADC
ADC calibration（refer as follow），NOTE: Not
adjust
OK
4-White balance
White Balance data adjustment（refer as follow）
The balance data is set by PE before the mass
production. Do not need adjust.
OK
5-SHOP
init(Option)
DO
Reset the set after production alignment;(This
operation will remove all unnecessary factory
value; The factory hotkey will be turn off)
OK
6-NVM reset
DO
System initialization. Restore all data except
the White Balance and ADC data ;Only for R&D.
OK
7-Preset Factory
Channel
DO/HZ Preset specific factory channels for specific
factory. Press left and right button to select
the factory, and then press OK to confirm.
NG
8-Power on mode
LAST
On: Always turns on TV when AC power on
STB：Always goes to standby mode when AC power
on
LAST：Restore the status before the last AC
power off
OK
