TCL HH42NK, User Manual, Page: 17 / 26

15
•. Wireless.Channel: Different regions use different channels (Channel 1-11
in FCC (US) / IC (Canada); Channel 1-13 in ETSI (Europe); Channel 1-13 in
MKK (Japan)).
5.3.2 Black.and.White.List
Add a blacklist to deny devices with the selected MAC address from
connecting to the network.
Add a white list to allow only the devices with the selected MAC address to
access the internet if the white list is empty, users will not be able to access
the Internet.
5.3.3 WPS
Open the WPS Function switch and click Apply ; press and hold the WPS
button for 3 seconds. The Wi-Fi LED will start to flash blue. Then press the
WPS button on the device you wish to connect to within two minutes. Your
Cat4 Router will automatically assign your network settings to the device you
wish to connect to.
5.4. Network Advanced
5.4.1. IPv6
Set up the WAN connection mode and parameters here. You can set the
connection mode to PPPoE, Dynamic IP or static IP.
PPPoE: PPPoE stands for Point-to-Point Protocol over Ethernet. This is a
network protocol that is mainly used for DSL services whereby individual users
connect to a modem using an Ethernet connection. Enter the username and
password provided by your network service provider and click Apply .
Dynamic.IP: IPv6 uses two address autoconfiguration protocols, namely
Stateless Address Autoconfiguration Protocol (SLAAC) and IPv6 Dynamic
Host Configuration Protocol (DHCPv6). DHCPv6 is a network protocol used
to configure IP addresses, IP prefixes or other configurations required by IPv6
hosts working on IPv6 networks. When a host applying IPv6 receives a route
advertisement, it can create a process for it through a series of processes and
assign it a valid IPv6 routing address. This process is called "stateless address
auto-configuration (SLAAC for short)".
Static.IP: Access the internet using a fixed IP address, subnet mask, gateway IP
address and Primary DNS server. These should all be provided by your network
service provider.