EN
7
English
Getting started
Switch the TV on and off
1.
When the power cord is connected, the TV will be turned on directly or be in standby mode. If the TV is in
standby mode, press the or
POWER/
button on the set or the button on the remote control to turn it
on.
2.
To put the TV into standby mode, press the button on the remote control. The TV set remains powered up,
but with low energy consumption.
3.
To switch the TV off, unplug the mains plug from the mains outlet.
Initial setup
The first time you switch the set on, the
Hello
screen appears, which guides you through the initial setup
process. Follow the on-screen instructions to finish the initial setup process such as selecting the language,
scanning channels, and more. During each step, either make a choice or skip the step. If you skip a step, you
can perform the setup later from the settings menu.
Note: If the channel search retrieved only the analogue channels it could be caused by poor broadcasting and
therefore is not covered by manufacturer warranty. Manufacturers cannot be held responsible for lack of
or poor broadcasting in some areas.
Important
:
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Remove batteries when
the remote control is not to be used for a long time. Batteries left in equipment may cause damage through
deterioration and corrosive leakage, invalidating the guarantee.
To protect the environment use local recycling facilities for battery disposal. Dispose of used batteries
according to the instructions.
CAUTION
: Risk of explosion if batteries are replaced by an incorrect type. Replace only with the same or
equivalent type recommended by the equipment manufacturer.
If the batteries in your remote control are run down, you can use the buttons on your TV set. They have the
following functions:
1.
button
Turns the TV on from the standby mode. In TV mode, press to display the main menu. In menu mode, long
press for 2 seconds to confirm a selection (acts like the
OK
button on the remote). When the TV is on, long
press for 2 seconds to open or close the source list directly; long press for more than 3 seconds to turn off
the TV.
2. button
Decreases or increases the volume. In menu mode, they act like the
◄/►
buttons on the remote and adjust
menu controls.
(Note: In some menus, also acts like the
OK
button on the remote.)
3. button
Scans up or down through the channel list. In menu mode, they act like the
▲
/
▼
buttons on the remote and
adjust menu controls.
