CONFIG. M5000
M5CONFIG
Rev 1.3 Page 7
OPTION INSTALLATION
M5000
You have the facility to try the newest options within a certain time limit (normally 100
hours). First of all you need to install the new application software which is described in the
'SOFTWARE INSTALLATION' module in this section.
The option you want to install is in fact already in the M5000. However, a 20 character license
code and an 8 character subcode are needed to access the option. This is done by writing a
code in the M5000 generated only by TC Electronic. The code is based on a set of parameters
you must know before you order the option:
•
Serial number of the M5000 frame.
•
A four character reference code (only for temporary option installation)
When you want to order an option, either temporary or permanent, you need to supply your
dealer with these parameters. You will find them as follows:
SERIAL NUMBER
1.
Switch off the M5000.
2.
Press the BYPASS-button (
18
) and switch the power on again while pressing
the BYPASS-button. Hold it until the SETUP UTILITY-menu appears on the
display.
3.
Turn the PROGRAM-dial until you find the
SERIAL #
and then press DO.
As you can see on this page, you will find not only the serial number but also the BIOS
version and the size of the flash EPROM.
REF. CODE
This reference code is also needed for generating the specific license code and subcode.
Follow the procedure below:
4.
If you still are in the Setup Utility menu - switch the M5000 off and on again.
5.
Press the UTILITY-button (
17
) and turn the PROGRAM-button to the
CONFIG menu.
6.
Use soft dial A to find the wanted option.
7.
When you have found the wanted option press DO once.
OPTION
TIME
LEVEL
(Option name)
--
off
This display shows the status of the selected option.
8.
Press DO again;
LICENSE # (XXXX) : 0000000000000000000
CURSOR CHAR NUM
