CONFIG. M5000
M5CONFIG
Rev 1.2 Page 10
9.
The 4 character reference code for this option is found within the brackets,
shown above as (XXXX). This code is only needed when ordering the
temporary option with time limit.
Based on the parameters received from you by following the above procedure, a special
license code and subcode, which are unique for your frame, are generated at TC Electronic
headoffice in Denmark. This is the procedure regardless if you are ordering a temporary or
permanent option.
INSTALLING THE OPTION
10.
When you have received the 20 character license code and the 8 character
subcode, you can follow the steps 5 to 8 above, which should get you to the
page where you can dial in the 20 character license code. It is of vital
importance when selecting you select the option in step 7 that you select the
same option as you got the 4 character reference code from !
11.
Use softdial A, B and C as you dial the code.
12.
When the license code is dialed please check once again that the characters are
dialed correctly.
13.
Press DO and dial the subcode. Again double check the dialed characters.
14.
Press DO and
switch the M5000 off and then on
. If all codes were dialed
correctly and the option selected is correct the option is now installed.
If not:
The code is illegal
Press DO to continue
If this happens then start from step 10 again. Make sure that you select the right
option according to the reference code you gave to your dealer.
CHECK THE OPTION INSTALLED
You can check your installation by following procedure:
15.
Press the UTILITY-button (
17
) and turn the PROGRAM-button to the
CONFIG menu.
16.
Scroll trough the options by turning soft dial A. If you want to check one of the
options simply press DO. If LEVEL is ‘
off
’ the selected option is not installed.
'TIME' shows the time limit and counts down in hours and minutes unless it is
a permanently installed option. The time limit will in that case be 'forever'.
When the time is up you will get a warning and at the next power up the
temporary option is gone. Press UNDO to go back to the CONFIGURATION
MENU.
