8
Assembly
Disconnect the power plug before carrying out any adjustments or maintenance.
Auxiliary handle
The auxiliary handle (3) will provide additional control, support and guidance.Could be fitted
left/right/center by screwing in the desired place.
Installing wheel guard
The guard is mounted and positioned very easily thanks to the quick coupling.
Installing/replacing grinding wheel
ATTENTION! Operate the spindle lock button after complete stop of powertool
Unplug the appliance
Press and hold the spindle lock button (1) and turn the shaft until it stops
Remove the outer flange and support flange using the two heads key.
Mount the disk (6) using the flanges, then unlock the shaft.
Operation
Before pushing the on / off switch, check that the grinding disc is properly
installed and operates easily and if the flange is tight
Switching ON and OFF
Connect the tool to the power supply.
To start the machine, you squeeze the ON / OFF switch (2). To stop the machine, you release the
ON / OFF switch.
Let the wheel reach full speed. Apply grinder on the workpiece. Maximum efficiency is achieved
when the grinder is held at an angle of 15-30 ° to the workpiece. Move slowly the grinder along
the workpiece. It is not recommended to press hard the disc on the workpiece surface.
Cleaning and maintenance
Before performing any work on the equipment, pull the power plug.
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.If the dirt
does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Maintenance
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and regular
cleaning.
