TB Wood's X4, User Manual, Page: 57 / 98

1428D-0607 - 49 -
© 2007 TB Wood’s All Rights Reserved
Chapter 7: X4 Parameters
7.1 Introduction
The X4 AC drive incorporates a comprehensive set of parameters that allow you to configure the
device to meet the special requirements of your particular application.
Note that pressing the PROG key enters Level 1 programming. Press SHIFT+PROG to enter Level
2 programming. Press ENTER+PROG to show only those parameters that have changed from the
factory default values.
This chapter describes the available parameters and the values that may be assigned to them. The
parameter summary table at the front of this manual provides a summary of all parameters including
their ranges and default values.
7.2 Level 1 Parameters
The most commonly configured X4 parameters are stored in a group named Level 1. This group is
easily accessed by pressing the PROG key as described in “Chapter 5: Keypad Operation and
Programming” on page 30. The following table lists the parameters in this group; for further
information on the parameter, please turn to the indicated page.
Table 7-1: Parameters Available in Level 1 Programming (Factory Macro)
Para. # Parameter Name
See
Page Para. # Parameter Name
See
Page
001 Model Number 50 303 Preset Freq 1 55
010 Last Fault 50 402 Accel Time 1 56
102 Output Freq 51 403 Decel Time 1 56
103 Output Voltage 51 502 Voltage Boost 59
104 Output Current 51 610 Timed OL Select 64
105 Drive Load 51 700 Vmet Config 65
106 Load Torque 51 705 Relay 1 Select 66
107 Drive Temp 51 706 Relay 2 Select 66
111 DC Bus Voltage 51
201 Input Mode 52
202 Rev Enable 52
301 Min Frequency 55
302 Max Frequency 55