4
taylormadeproducts.com/wavemaker
574-537-8900
Rev:06.05.20
Taylor Made
®
Exciter Speaker
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003868
Manual information may be distributed as a complete
document only, unless Lippert Components provides
explicit consent to distribute individual parts.
All manual information is subject to change without
notice. Revised editions will be available for free
download at
. Manual information is considered
factual until made obsolete by a revised version.
Please recycle all obsolete materials and contact
Lippert Components with concerns or questions.
9.
When installing the cover, make sure to align the support
areas with the mating shapes
(Fig.5)
. Also check to make
sure that the tabs and wires are in the extended area so
that the speaker wires run through the gap at the bottom of
the cover
(Fig.5)
.
Fig.5
completed
connection
extended area
open end
Fig.6
mating
shapes
10.
After the speaker wires have been connected
(Fig.6)
,
remove the protective film from the adhesive on the Exciter
cover. Set cover into position as shown in figure 6 with the
open end of the cover at the bottom.
correct
placement
DO NOT TRY TO REMOVE OR REPOSITION THE
EXCITER ONCE IT HAS ADHERED TO THE GLASS AS
THIS CAN CAUSE DAMAGE TO THE SPEAKER.
6.
After the Exciter is in place, firmly press and hold down
on each of the three support pad
(Fig.4)
areas for one
minute to assure good adhesion to the glass.
7.
Press down on the center section
(Fig.4)
of the Exciter for
one minute to assure good adhesion of the driver to the glass.
8.
Connect speaker wires to the speaker. The red terminal
is positive and the silver terminal is negative
(Fig.4)
.
Fig.4
center driver
support pad
support pad
speaker wires
positive terminal
negative terminal
black
red
11.
After the cover is in the correct position, firmly press and
hold the cover for one minute to assure good adhesion of
the cover to the driver.
12.
Repeat steps 4 through 11 for other Exciters.
