31
EQUIPMENT SETUP AND CLOSE PROCEDURES
The two-platen Model C852 has been selected to
illustrate the step-by-step procedures in this manual. For
grills equipped with less than two platens, perform the
following steps as appropriate for your grill platen
configuration.
Installing Upper Platen Release Sheets
1.
Carefully wrap the release sheet side flaps over the
side cover rails. Secure the sheet with the locking
clips. The back edge of the sheet will not be secured,
but instead will hang free. See Figure-17.
Figure-17
2.
Center the release sheet on the front of the upper
platen. Pull it tightly over the release material cover
rail located in the front of the platen and secure it with
a locking clip. See Figure-18.
Figure-18
Important!
Do not
crease the release sheet. This will
greatly reduce the life of the sheet.
3.
Make sure the release sheets are tight across the
upper platen surface.
4. Repeat step 1 through step 3 for the other upper
platen on Models C852, C856, and C858.
Changing Release Sheets
The release sheet must be changed when:
•
Product sticks to the release sheet.
•
Carbon builds up, causing problems in taste or
appearance.
•
There is a tear in the release sheet in the cooking
area.
•
The release material substance is worn from the
release sheet.
Note:
Reverse the cooking side of the release sheets on
a daily basis
(example: black side on odd days; gray or
brown side on even days).
Proper Care for Release Sheets
•
Do not
fold or crease.
•
Do not
touch with any sharp object or abrasive.
•
Do not
hose with hot water or soak in water.
•
Do not
place under other objects.
Startup Grill
Important!
The lower grill plate and the upper platen
must be clean before starting these procedures.
Note:
Grills that use lower release sheets require startup
of grill before installation of lower release sheets.
1. Place the fan interlock switch in the ON position. The
controller will initialize and then display the following
screen (see Figure-19):
Figure-19