Taylor C722, Operating Instructions Manual, Page: 35 / 67

31 Model C722 Operating Procedures
120507
Step 7
Insert the valve body cap into the hole in the mix
inlet adapter. (See Figure 64.)
Figure 64
Step 8
Insert the mix inlet assembly into the pump cylinder.
(See Figure 65.)
Figure 65
The adapter must be positioned into the notch
located at the end of the pump cylinder.
Step 9
Secure the pump parts in position by sliding the
retaining pin through the cross holes located at one
end of the pump cylinder. (See Figure 66.)
Figure 66
Note: The head of the retaining pin should be
located at the top of the pump when installed.
Step 10
Assemble the feed tube assembly. Slide the check
ring into the groove of the feed tube.
(See Figure 67.)
Figure 67