C713 Operator Training
C713 Operator Training
12
C713 Operator Training
C713 Operator Training
Step 1
Before installing the beater drive shaft, lubricate the groove on the beater drive shaft.
Step 2
Slide the beater drive shaft boot seal over the small end of the beater drive shaft and engage into
the groove on the shaft.
Step 3
Heavily lubricate the inside portion of the boot seal and also lubricate the flat end of the boot seal
that comes in contact with the rear shell bearing.
Step 4
Apply an even coat of lubricant to the shaft. DO NOT lubricate the hex end.
Note: To ensure the mix does not leak out of the back of the freezing cylinder, the middle section of
the boot seal should be convex or extend out from the seal. If the middle section of the boot seal is
concave or extending into the middle of the seal, turn the seal inside out.
Step 5
Insert the beater drive shaft through the rear shell bearing in the freezing cylinder and engage the
hex end firmly into the drive coupling.
Step 6
Before installing the beater assembly, check the scraper blades. If they are in good condition,
take one of the scraper blades and slip it under the hook at the front of the beater. Wrap the blade
around the beater, following the helix and pushing the blade down onto the helix as you wrap. At the
back end of the beater, slip the blade under the hook.
Repeat this step for the second scraper blade.
Step 7
Holding the beater securely, slide the beater into the freezing cylinder about one-third of the way in.
Looking into the freezing cylinder, align the hole at the rear of the beater with the flats on the end of
the drive shaft.
Step 8
Slide the beater the remainder of the way into the freezing cylinder and over the end of the drive
shaft. The beater should fit snugly but not so tightly that the beater cannot be turned slightly to
engage the drive shaft.
Make sure the beater assembly is in position over the drive shaft. Turn the beater slightly to be
certain that the beater is properly seated. When in position, the beater will not protrude beyond the
front of the freezing cylinder.
Step 9
Repeat these steps for the other side of the machine.
Freezing Cylinder Assembly
