Taylor C706, Original Operating Instructions

Page: 20 / 47

16
Model C706 Operating Procedures
041118
Insert the drive shaft into the freezing cylinder, hex end
first, and into the rear shell bearing until the seal fits
securely over the rear shell bearing. Engage the hex
end firmly into the drive coupling. Be sure the drive
shaft fits into the drive coupling without binding.
Figure 7
Step 2
Install the beater assembly. First check the scraper
blades for any nicks or signs of wear. If any nicks are
present, or if the blades are worn, replace both blades.
If the blades are in good condition, install the scraper
blade clips on the scraper blades. Place the rear
scraper blade over the rear holding pin on the beater.
Note: The hole on the scraper blade must fit securely
over the pin to prevent costly damage.
Figure 8
Holding the rear blade on the beater, slide it halfway in-
to the freezing cylinder. Install the front scraper blade
over the front holding pin.
Install the beater shoes.
Figure 9
Slide the beater assembly the rest of the way into the
freezing cylinder.
Make sure the beater assembly is in position over the
drive shaft. Turn the beater slightly to be certain that
the beater is properly seated. When in position, the
beater will not protrude beyond the front of the freezing
cylinder.
Step 3
Assemble the freezer door. Place the large rubber
gasket into the groove on the back side of the freezer
door.
Slide the white plastic front bearing over the baffle rod
onto the bearing hub making certain that the flanged
end of the bearing is resting against the freezer door.
Do not lubricate the gasket or the front bearing.
Figure 10