6
Models 750, 751, 754, 774, 791, 794
Safety
130819
S
DO NOT
allow untrained personnel to operate
this machine.
S
DO NOT
put objects or fingers in door spout.
S
DO NOT
operate the freezer unless all service
panels and access doors are restrained with
screws.
S
DO NOT
remove any internal operating parts
(example: freezer door, beater, scraper
blades, etc.) unless all control switches are in
the OFF position.
Failure to follow these instructions may result in
contaminated product or severe personal injury to
fingers or hands from hazardous moving parts.
This unit has many sharp edges that can
cause severe injuries.
S
DO NOT
put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
S
USE EXTREME CAUTION
when removing
the beater asssembly. The scraper blades are
very sharp.
Failure to follow these instructions may result in
electrocution or damage to the machine. Contact your
local authorized Taylor Distributor for service.
This freezer must be placed on a level
surface. Failure to comply may result in personal injury
or equipment damage.
Cleaning and sanitizing schedules are
governed by your state or local regulatory agencies
and must be followed accordingly. Please refer to the
cleaning section of this manual for the proper
procedure to clean this unit.
Access to the service area of the unit must be
restricted to persons having knowledge and practical
experience with the unit, in particular as far as safety
and hygiene are concerned.
DO NOT
run the unit without product. Failure to follow
this instruction can result in damage to the unit.
DO NOT
obstruct air intake and discharge openings:
Counter Model:
6” (152 mm) minimum air space on
both sides and 0” on the rear.
Console Models:
3” (76 mm) minimum air space on
all sides.
Failure to follow this instruction may cause poor
freezer performance and damage to the machine.
These freezers are designed to operate indoors, under
normal ambient temperatures of 70
_
−
75
_
F
(21
_
−
24
_
C). The freezers have successfully
performed in high ambient temperatures of 104
_
F
(40
_
C) at reduced capacities.
NOISE LEVEL:
Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.
