Taylor 490, Operator Training

Page: 36 / 70

Model 490 Operator Training
Controls Operating Procedures Troubleshooting Quiz
Quit
Home
Operating
Procedures
Brush Cleaning
Assembly
Sanitizing
Draining
Cleaning
Priming
Disassembly
Brush Cleaning
Rinsing
Operating Procedures
Step 4
Remove the draw valve and prime plug from the
freezer door. Remove the two o rings from the
draw valve and the o-ring from the prime plug.
Note: To remove o-rings, use a single service
towel to grasp the o-ring. Apply pressure in an
upward direction until the o-ring pops out of its
groove. With the other hand, push the top of the
o-ring forward and it will roll out of the groove
and can be easily removed. If there is more
than one o-ring to be removed, always remove
the rear o-ring first. This will allow the o-ring to
slide over the forward o rings without falling into
the open grooves.
Step 5
Thoroughly brush clean all disassembled parts
in the cleaning solution, making sure all
lubricant and mix film is removed. Take
particular care to brush clean the draw valve
core in the freezer door. Place all the cleaned
parts on a clean, dry surface to air dry
overnight.