4.8 BEVERAGE EQUIPMENT:
4.8.6.3 Iced Cappuccino Machine
13
Issue Date: February 21, 2008
Taylor 390
Last Modified: October 31, 2008
6. To assemble the door with the ice buster, install the O-Rings on the draw
valve and lubricate. Insert the draw valve into the door spout, leaving
approximately 1/2” of the valve sticking out the top of the door and ensuring
that the hole for the handle is positioned on the left side and rotate the draw
valve so the flats on the top of the draw valve are perpendicular to the door
face (Diagram A on Page 9).
7. Insert the ice buster through the door spout and into the slot located just
above the lower O-Ring. With the ice buster in place, rotate the draw valve to
allow installation of the draw handle. This will lock the ice buster in place.
With the draw valve handle in place, install the draw valve pin and rotate the
draw valve handle to allow the draw valve pin to fall into place. Insert the
prime plug into the freezer door, but do not tighten fully (needs to be open to
allow excess air to escape during hopper filling).
NOTE: Do not lubricate the door gasket or front bearing.
8. To install the freezer door, place the front end of the torque rotor into the hole
in the center of the door. Position the door onto the four studs on the front of
the freezing cylinder and push the door into place. Insert the torque arm
between the draw valve spout supports and into the hole in the torque
assembly. Replace the four stud nuts onto the studs and tighten them equally
in a criss-cross pattern to insure the door is snug.
DO NOT
over-tighten.
INSERT
INTO
HOLE
All manuals and user guides at all-guides.com