17
800-628-5188
Rev: 10.13.21
Taylor Made
®
Manual Bimini
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004206
A
B
Opening the Bimini Top
Opening the bimini top from the radar position:
1.
Unzip and remove the boot from the bimini top. Store the
boot on board the pontoon for later use.
2.
Pull the front frame forward until the bimini top is
fully opened.
3.
Remove the quick-release ring pins from the
adjustable front supports, then lower the supports into
their H-brackets.
4.
Align the adjustable front inner support tubes’ pivot
holes with the H-bracket pivot holes, then reinsert the
previously removed (step 3) quick-release ring pins.
Fig.46
4.
Carefully lower the bimini top assembly down to rest on
the rear pontoon fence railing
(Fig.46A)
, then let the rear
support tubes down to rest inside the H-brackets
(Fig.46B)
.
Opening the bimini top from the fully collapsed position:
1.
Remove the quick-release ring pins from the rear
support tubes’ pivot holes.
2.
With the boot still installed, grasp the rear support tubes
and carefully raise the bimini top until the rear support
tubes reach their H-brackets.
3.
Align the rear support tubes’ pivot holes with the
H-bracket pivot holes, then reinsert the previously removed
(step 1) quick-release ring pins.
4.
Unzip and remove the boot from the bimini top. Store the
boot on board the pontoon for later use.
5.
Pull the front frame forward until the bimini top is
fully opened.
6.
Remove the quick-release ring pins from the adjustable
front supports, then lower the supports down into their
H-brackets.
7.
Align the adjustable front inner support tubes’ pivot holes
with the H-bracket pivot holes, then reinsert the previously
removed (step 6) quick-release ring pins.
