![background image](http://html1.mh-extra.com/html/taylor-dunn/tiger-tc50e/tiger-tc50e_operators-manual_3778306050.webp)
Page 50
C0-T50-80 Owners Manual
MC-TC50E-01
TIRES
Changing a Tire/Wheel assembly
Note: A spare tire, jack, or lug wrench is not attached to the vehicle.
6. Loosen the wheel nuts (do not remove) before raising the tire off of the ground.
7. Raise the tire to be changed off of the ground and support with a jack stand.
8. Remove the wheel nuts and tire/wheel assembly.
9. Install the replacement tire/wheel assembly.
10. Install the wheel nuts and cross tighten per illustration below to 85 foot pounds (115 Nm).
11.
Check the tire for proper inflation.
12. Lower the vehicle to the ground and remove the blocks from the wheels.
13.
Wheel nuts should be checked for tightness after first 100 miles (10 hours of operation).
Incorrect tire inflation can result in sudden failure of the tire and/or braking / steering
problems leading to loss of control of the vehicle.
Never exceed the maximum pressure as indicated on the side wall of the tire. Exceeding the
maximum pressure may cause explosive failure of the tire resulting in severe bodily injury.
WARNING
1) Park the vehicle on a hard level surface off of any main road or highway.
2) Make sure the Start switch is in the OFF position, then remove the key.
3) Place the Shift Lever in the center OFF position.
4) Set the park brake.
5) Block the wheels on the opposite side of the tire to be changed.
WARNING
When lifting the vehicle, always use a hoist with lifting strap, or a jack of adequate
capacity. Use jack stands to support the vehicle before starting any repairs. Failure to
use lifting and support devices of rated load capacity may result in severe bodily injury.
WARNING