Taylor-Dunn SC-090-24, Operation, T Roubleshooting And Replacement Parts Manual

Page: 41 / 130

Maintenance, Service, and Repair
Steering Components
Page 7
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
FORK BEARINGS
6. Raise the front of the vehicle and support with jack stands.
7. Inspect for lateral play by attempting to move the fork to the left and right (not rotating), There
should be no noticeable play.
8. If there is any play in the fork bearings, refer to section
Replace the Front Fork
for information
regarding adjusting the fork bearings.
9. Lower the front end to the ground.
10. Reconnect the main positive and negative cables at the batteries.
11. Remove the blocks from behind the wheels.
12. Release the parking brake and test drive the vehicle.