Taylor-Dunn SC-090-24, Operation, T Roubleshooting And Replacement Parts Manual

Page: 37 / 130

Maintenance, Service, and Repair
Steering Components
Page 3
Center the Steering Wheel
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Do not drive the vehicle while the steering wheel or front wheels
are tied in position. Driving the vehicle while the steering wheel or
front wheels tied in position may cause loss of control of the vehicle
resulting in severe bodily injury and/or property damage.
6. Position the front fork in the straight ahead position and tie it off so that it cannot rotate.
7. Remove the steering chain access plate.
8. Remove the safety wire from the turn buckles and
discard.
9. Loosen the turn buckles just enough to remove the
chain from the lower sprocket
10. Center the steering wheel as shown in the illustration
and tie it off so that it cannot rotate.
11. Position the chains so that the turnbuckles are
an equivalent distance from the steering wheel
sprocket. See illustration to the right.
12. Install the chain on the lower sprocket.
Steering wheel removed for clarity