Taylor-Dunn MX6-00, Operation, Troubleshooting Manual

Page: 49 / 200

3-25
Optional Geared Steering
Here, we will cover the optional geared steering assembly. This assembly is an
option on all three vehicles.
In this section, we will cover how to remove and service this steering system.
SS5-34 Geared Steering Assembly
In order to disassemble this steering gear box, follow this procedure. Refer to the
illustration on the following page.
1. Park the vehicle on a level surface and block all the wheels.
2. Remove the cap from the center of the steering wheel.
3. Remove the nut from the center of the steering wheel.
4. Remove the steering wheel and woodruff key from the shaft.
5. Remove the 6 bolts from the top cover.
6. Lift the top cover off the gear box, discarding the gasket.
NOTE: The spur gear and shaft may come out of the gear box
when removing the top cover. Do not let the gears drop to the
floor.
7. Remove as much grease as possible from the inside of the gear box
and dispose of it properly.
8. Remove the gear case and clean the remaining grease from the
bottom of the gear box.
9. Remove and discard the lower gasket.
10. Remove the 3 remaining bolts from the bottom of the gear box.
11. Clean all parts except for the gaskets in solvent.
12. Reassemble in reverse order, installing new gaskets.
NOTE: Check the bronze bushings for wear and replace them
as needed.
13. Fill the gear box with grease.