Brakes
Page 53
ME-45X-01
E-451 & E-457
INSPECTION
The band brake is located on the front of the drive chain
case housing; the band must be removed to accurately
measure the lining thickness. Refer to the Replace Brake
Band section for information on removing the band brake.
1: Measure the thickness of the brake lining at its
thinnest point. If it is less than specified in the
service limits at the end of this section then the
brake band must be replaced.
2: Measure the run out of the brake drum. If it is
more specified in the service limits at the end of
this section then it must be machined or replaced.
Do not machine the brake drum beyond its
service limits.
3: Measure the diameter of the brake drum. If it is
less than specified in the service limits at the
end of this section then the brake drum must be
replaced.
4: Inspect all brake cables and linkages for any
signs of damage or wear.
5: Refer to the Replace Brake Band section for
information on reinstalling the band.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING
ADJUST SERVICE BRAKE
1: Press the accelerator treadle until the stop nut on
the throttle rod is in contact with the accelerator
module slip joint (see illustration).
2: Loosen the brake band
bolt jam nut.
3: Tighten the brake band
bolt until the brake
starts to drag and then
back off one turn.
4: Tighten the brake band
bolt jam nut.
5: Release the treadle.
6: Reconnect the battery.
7: Remove the blocks from the wheels.
8: Test drive the vehicle.
Note: Back off of the adjustment slightly if there
any brake drag is noticed in the test drive.
Summary of Contents for E-451
